产品概述 返回TOPJjU嘉泰姆

The CXDR75120/CXDR75121 are microprocessor (μP) supervisory circuits used to monitor the power supplies in μP and digital systems. They provide excellent circuit reliability and low cost. These circuits perform a single function: they assert a reset signal whenever the VCC supply voltage declines below a preset threshold, with hysteresis keeping it asserted for time delay determined by externally programmable time delay generator after VCC has risen above the reset threshold. The CXDR75121L has an open-drain output stage, while the CXDR75120 have push-pull outputs. The GCXDR75121’s open-drain RESET output requires a pull-up resistor that can be connected to a voltage higher than VCC. The GCXDR75120 has an active-low RESET output, while the GCXDR75120 has an active-high RESET output. The outputs are guaranteed to be in the correct logic state for VCC down to 0.8V. The CXDR75120/CXDR75121 are available in 5-pin TSOT-23-5 package.

   产品特点 返回TOPJjU嘉泰姆

„ Precision Monitoring Voltage of +2.2V and +3.7V JjU嘉泰姆

„ Fully Specified Over Temperature JjU嘉泰姆

„ Available in Three Output Configurations Push-Pull RESET Output (CXDR75120L) Push-Pull RESET Output (CXDR75120H) Open-Drain RESET Output (CXDR75121L) JjU嘉泰姆

„ Reset Deassert Time Smaller than 100μs when VCC Higher than Monitor Voltages (CD Pin Floating) JjU嘉泰姆

 „ Externally Programmable Time Delay Generator JjU嘉泰姆

„ 27μA Supply Current at VCC=3.3V JjU嘉泰姆

„ Guaranteed Reset Valid to VCC = 0.8V JjU嘉泰姆

„ TSOT-23-5 Packages JjU嘉泰姆

„ 2% Threshold AccuracyJjU嘉泰姆

   应用范围 返回TOPJjU嘉泰姆

„ Computers JjU嘉泰姆

„ Controllers JjU嘉泰姆

„ Intelligent Instruments JjU嘉泰姆

„ Critical μP and μC Power Monitoring JjU嘉泰姆

„ Portable / Battery-Powered Equipment JjU嘉泰姆

„ AutomotiveJjU嘉泰姆

   技术规格书（产品PDF) 返回TOP JjU嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！JjU嘉泰姆