CXSD62136功率mosfet 2A连续输出电流同步buck变换器4.5V宽输入电压转换为24V固定340kHz开关频率低ESR电容稳定
发表时间:2020-04-27
浏览次数:299

1.产品概述                       2.产品特点fw2嘉泰姆
3.应用范围                       4.下载产品资料PDF文档 fw2嘉泰姆
5.产品封装图                     6.电路原理图                   fw2嘉泰姆
7.功能概述                        8.相关产品fw2嘉泰姆

一,产品概述(General Description)     CXSD62136 CXSD62136B is a 2A synchronous buck converter with integrated power MOSFETs.The CXSD62136 CXSD62136B design with a current-mode control scheme, can convert wide input voltage of 4.5V to 24V to the output voltage adjustable from 0.92V to 20V to provide excellent output voltage regulation. The CXSD62136 CXSD62136B is also equipped with Power-on-reset, softstart, and whole protections (over-temperature, and current-limit) into a single package.This device, available SOP-8, provides a very compact system solution external components and PCB area  fw2嘉泰姆

二.产品特点(Features)fw2嘉泰姆

Wide Input Voltage from 4.5V to 24Vfw2嘉泰姆
2A Continuous Output Currentfw2嘉泰姆
Adjustable Output Voltage from 0.92V to 20Vfw2嘉泰姆
Intergrated N-MOSFETfw2嘉泰姆
Fixed 340kHz Switching Frequencyfw2嘉泰姆
Stable with Low ESR Capacitorsfw2嘉泰姆
Power-On-Reset Detectionfw2嘉泰姆
Programmable Soft-Startfw2嘉泰姆
Over-Temperature Protectionfw2嘉泰姆
Over-Voltage Protectionfw2嘉泰姆
Current-Limit Protection with Frequency Foldbackfw2嘉泰姆
Enable/Shutdown Functionfw2嘉泰姆
Small SOP-8 Packagefw2嘉泰姆
Lead Free and Green Devices Available (RoHS Compliant)fw2嘉泰姆

三,应用范围 (Applications)fw2嘉泰姆

LCD Monitor/TVfw2嘉泰姆
Set-Top Boxfw2嘉泰姆

DSL, Switch HUBfw2嘉泰姆
Notebook Computerfw2嘉泰姆

四.下载产品资料PDF文档 fw2嘉泰姆


需要详细的PDF规格书请扫一扫微信联系我们,还可以获得免费样品以及技术支持fw2嘉泰姆

 QQ截图20160419174301.jpgfw2嘉泰姆

五,产品封装图 (Package)fw2嘉泰姆


blob.pngfw2嘉泰姆

六.电路原理图fw2嘉泰姆


blob.pngfw2嘉泰姆

Main Control Loop The CXSD62136 CXSD62136B is a constant frequency current mode switching regulator. During normal operation, the inter-fw2嘉泰姆

nal N-channel power MOSFET is turned on each cycle when the oscillator sets an internal RS latch and wouldfw2嘉泰姆
be turned off when an internal current comparator (ICMP) resets the latch. The peak inductor current at which ICMPfw2嘉泰姆
resets the RS latch is controlled by the voltage on the COMP pin, which is the output of the error amplifierfw2嘉泰姆
(EAMP). An external resistive divider connected between VOUT and ground allows the EAMP to receive an outputfw2嘉泰姆
feedback voltage VFB at FB pin. When the load current increases, it causes a slight decrease in VFB relative tofw2嘉泰姆
the 0.92V reference, which in turn causes the COMP volt- age to increase until the average inductor current matchesfw2嘉泰姆
the new load current. fw2嘉泰姆
VIN Power-On-Reset (POR) and EN Under-voltage Lockoutfw2嘉泰姆
The CXSD62136 CXSD62136B keep monitoring the voltage on VIN pin to prevent wrong logic operations which may occur when VIN voltage is not high enough for the internal control circuitry to operate. The VIN POR has a rising thresholdfw2嘉泰姆
of 4.1V (typical) with 0.5V of hysteresis.An external under-voltage lockout (UVLO) is sensed at the EN pin. Thefw2嘉泰姆
EN UVLO has a rising threshold of 2.5V with 0.2V of hysteresis. The EN pin should be connectedfw2嘉泰姆
a resistor divider from VIN to EN.After the VIN and EN voltages exceed their respective voltage thresholds,fw2嘉泰姆
the IC starts a start-up process and then ramps up the output voltage to the setting of output voltage.fw2嘉泰姆
Over-Temperature Protection (OTP)fw2嘉泰姆
The over-temperature circuit limits the junction tempera-ture of the CXSD62136 CXSD62136B. When the junction temperature ex-ceeds TJ = +160oC, a thermal sensor turns off the power MOSFET, allowing the devices to cool. The thermal sen-sor allows the converter to start a start-up process and regulate the output voltage again after the junction tem-fw2嘉泰姆
perature cools by 50oC.The OTP is designed with a 50oC hysteresis to lower the average TJ during continuous thermal overload conditions,increasing lifetime of the lC.fw2嘉泰姆
Enable / Shutdownfw2嘉泰姆
Driving EN to ground places the CXSD62136 CXSD62136B in shutdown. When in shutdown, the internal power MOSFET turns off,all internal circuitry shuts down.fw2嘉泰姆
Current-Limit Protectionfw2嘉泰姆
The CXSD62136 CXSD62136B monitors the output current, flowing through the N-Channel power MOSFET, and limits thefw2嘉泰姆
IC from damages during overload, short-circuit and over- voltage conditions. fw2嘉泰姆
Frequency Foldbackfw2嘉泰姆
The foldback frequency is controlled by the FB voltage.When the FB pin voltage is under 0.6V, the frequency offw2嘉泰姆
the oscillator will be reduced to 110kHz. This lower fre-quency allows the inductor current to safely discharge,fw2嘉泰姆
thereby preventing current runaway. The oscillator’s fre-quency will switch to its designed rate when the feedbackfw2嘉泰姆
voltage on FB rises above the rising frequency foldback threshold (0.6V, typical) again.fw2嘉泰姆
Over-Voltage Protectionfw2嘉泰姆
The over-voltage function monitors the output voltage by FB pin. When the FB voltage increase over 120% of thefw2嘉泰姆
reference voltage, the over-voltage protection compara-tor will force the low-side MOSFET gate driver high. Thisfw2嘉泰姆
action actively pulls down the output voltage. As soon as the output voltage is within regulation, the OVP compara-fw2嘉泰姆
tor is disengaged. The chip will restore its normal operation.fw2嘉泰姆

八,相关产品         更多同类产品.......fw2嘉泰姆