中文 English

CXSD62136

CXSD62136采用电流模式控制方案设计，可以将4.5V到24V的宽输入电压转换为0.92V到20V的可调输出电压，提供良好的输出电压调节还配备了上电复位、软启动和整体保护（超温和电流限制）到一个单独的包中

CXSD62136功率mosfet 2A连续输出电流同步buck变换器4.5V宽输入电压转换为24V固定340kHz开关频率低ESR电容稳定

产品手册

产品订购

产品简介

1.产品概述                       2.产品特点Ra1嘉泰姆
3.应用范围                       4.下载产品资料PDF文档 Ra1嘉泰姆
5.产品封装图                     6.电路原理图                   Ra1嘉泰姆
7.功能概述                        8.相关产品Ra1嘉泰姆

一,产品概述(General Description)     CXSD62136 CXSD62136B is a 2A synchronous buck converter with integrated power MOSFETs.The CXSD62136 CXSD62136B design with a current-mode control scheme, can convert wide input voltage of 4.5V to 24V to the output voltage adjustable from 0.92V to 20V to provide excellent output voltage regulation. The CXSD62136 CXSD62136B is also equipped with Power-on-reset, softstart, and whole protections (over-temperature, and current-limit) into a single package.This device, available SOP-8, provides a very compact system solution external components and PCB area  Ra1嘉泰姆

二.产品特点(Features)Ra1嘉泰姆

Wide Input Voltage from 4.5V to 24VRa1嘉泰姆
2A Continuous Output CurrentRa1嘉泰姆
Adjustable Output Voltage from 0.92V to 20VRa1嘉泰姆
Intergrated N-MOSFETRa1嘉泰姆
Fixed 340kHz Switching FrequencyRa1嘉泰姆
Stable with Low ESR CapacitorsRa1嘉泰姆
Power-On-Reset DetectionRa1嘉泰姆
Programmable Soft-StartRa1嘉泰姆
Over-Temperature ProtectionRa1嘉泰姆
Over-Voltage ProtectionRa1嘉泰姆
Current-Limit Protection with Frequency FoldbackRa1嘉泰姆
Enable/Shutdown FunctionRa1嘉泰姆
Small SOP-8 PackageRa1嘉泰姆
Lead Free and Green Devices Available (RoHS Compliant)Ra1嘉泰姆

三,应用范围 (Applications)Ra1嘉泰姆

LCD Monitor/TVRa1嘉泰姆
Set-Top BoxRa1嘉泰姆

DSL, Switch HUBRa1嘉泰姆
Notebook ComputerRa1嘉泰姆

四.下载产品资料PDF文档 Ra1嘉泰姆

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！Ra1嘉泰姆

 QQ截图20160419174301.jpgRa1嘉泰姆

五,产品封装图 (Package)Ra1嘉泰姆

blob.pngRa1嘉泰姆

六.电路原理图Ra1嘉泰姆

blob.pngRa1嘉泰姆

Main Control Loop The CXSD62136 CXSD62136B is a constant frequency current mode switching regulator. During normal operation, the inter-Ra1嘉泰姆

nal N-channel power MOSFET is turned on each cycle when the oscillator sets an internal RS latch and wouldRa1嘉泰姆
be turned off when an internal current comparator (ICMP) resets the latch. The peak inductor current at which ICMPRa1嘉泰姆
resets the RS latch is controlled by the voltage on the COMP pin, which is the output of the error amplifierRa1嘉泰姆
(EAMP). An external resistive divider connected between VOUT and ground allows the EAMP to receive an outputRa1嘉泰姆
feedback voltage VFB at FB pin. When the load current increases, it causes a slight decrease in VFB relative toRa1嘉泰姆
the 0.92V reference, which in turn causes the COMP volt- age to increase until the average inductor current matchesRa1嘉泰姆
the new load current. Ra1嘉泰姆
VIN Power-On-Reset (POR) and EN Under-voltage LockoutRa1嘉泰姆
The CXSD62136 CXSD62136B keep monitoring the voltage on VIN pin to prevent wrong logic operations which may occur when VIN voltage is not high enough for the internal control circuitry to operate. The VIN POR has a rising thresholdRa1嘉泰姆
of 4.1V (typical) with 0.5V of hysteresis.An external under-voltage lockout (UVLO) is sensed at the EN pin. TheRa1嘉泰姆
EN UVLO has a rising threshold of 2.5V with 0.2V of hysteresis. The EN pin should be connectedRa1嘉泰姆
a resistor divider from VIN to EN.After the VIN and EN voltages exceed their respective voltage thresholds,Ra1嘉泰姆
the IC starts a start-up process and then ramps up the output voltage to the setting of output voltage.Ra1嘉泰姆
Over-Temperature Protection (OTP)Ra1嘉泰姆
The over-temperature circuit limits the junction tempera-ture of the CXSD62136 CXSD62136B. When the junction temperature ex-ceeds TJ = +160oC, a thermal sensor turns off the power MOSFET, allowing the devices to cool. The thermal sen-sor allows the converter to start a start-up process and regulate the output voltage again after the junction tem-Ra1嘉泰姆
perature cools by 50oC.The OTP is designed with a 50oC hysteresis to lower the average TJ during continuous thermal overload conditions,increasing lifetime of the lC.Ra1嘉泰姆
Enable / ShutdownRa1嘉泰姆
Driving EN to ground places the CXSD62136 CXSD62136B in shutdown. When in shutdown, the internal power MOSFET turns off,all internal circuitry shuts down.Ra1嘉泰姆
Current-Limit ProtectionRa1嘉泰姆
The CXSD62136 CXSD62136B monitors the output current, flowing through the N-Channel power MOSFET, and limits theRa1嘉泰姆
IC from damages during overload, short-circuit and over- voltage conditions. Ra1嘉泰姆
Frequency FoldbackRa1嘉泰姆
The foldback frequency is controlled by the FB voltage.When the FB pin voltage is under 0.6V, the frequency ofRa1嘉泰姆
the oscillator will be reduced to 110kHz. This lower fre-quency allows the inductor current to safely discharge,Ra1嘉泰姆
thereby preventing current runaway. The oscillator’s fre-quency will switch to its designed rate when the feedbackRa1嘉泰姆
voltage on FB rises above the rising frequency foldback threshold (0.6V, typical) again.Ra1嘉泰姆
Over-Voltage ProtectionRa1嘉泰姆
The over-voltage function monitors the output voltage by FB pin. When the FB voltage increase over 120% of theRa1嘉泰姆
reference voltage, the over-voltage protection compara-tor will force the low-side MOSFET gate driver high. ThisRa1嘉泰姆
action actively pulls down the output voltage. As soon as the output voltage is within regulation, the OVP compara-Ra1嘉泰姆
tor is disengaged. The chip will restore its normal operation.Ra1嘉泰姆

八,相关产品         更多同类产品.......Ra1嘉泰姆

◀ 上一篇:85mW功率mosfet的3A同步降压变换器CXSD62135 4.5V至24V的宽输入电压

返回顶部

下一篇▶:2A连续输出电流CXSD62136B过电压保护可编程软启动开机复位检测固定340kHz开关频率低ESR电容稳定

诚芯电子 网店 嘉泰姆
深圳市嘉泰姆实业发展有限公司 版权所有
粤ICP备13004986号