CXPC3347

CXPC3347是一个电源管理单元(PMU),具有1个同步降压和1个CMOS低压差提供最大
Buck输出电流为1A,最大值为LDO输出电流为0.5A。同步buck是一种高效率的DC-toDC
降压开关调节器,能够输出电流可达1A。装置在2.6V至6V,提供0.6V至VDD,使buck成为低压电源的理想选择转换。以固定频率运行1.5MHz允许使用小型外部元件,如陶瓷输入和输出帽子,还有小感应器提供低输出波纹。这么低的噪音产出及其所达到的卓越效率
通过内部同步整流器,使buck大功率的理想绿色替代品消耗线性调节器。内部软启动
控制电路减少浪涌电流。短路热过载保护改善设计可靠性。LDO是一个低辍学率的调节器
最大电流0.5A输出。典型辍学负载电流为0.5A时的电压为0.8V,性能优良负载和线路瞬态响应良好温度特性,可以保证芯片和电源系统的稳定性。输出通过微调,精度设定在2%以内。典型的LDO输出电压:VOUT=1.8V。其他固定电压可在每0.1V步进1.2V~4.5V。也可以是根据命令定制。LDO也可以工作在2V到6V的宽输入电压下。它们可以提供折叠短路保护和输出电流限制功能。BL8087可用于无铅DFN2X2-8(带外露散热垫)包装
高效:高达97%
可输送1A
1.5MHz开关频率
不需要外部肖特基二极管
低辍学率100%工作
内部补偿和软启动
电流模式控制
低输出电压下的0.6V参考电压
逻辑控制关闭(IQ<1uA)
热停堆,UVLO和OVP
LDO公司
最大输出电流为0.5A
输入电压范围:2-6V
输出电压范围:1.2V~4.5V(每0.1V步按指令定制)
低功耗:40uA(典型)
低输出噪声(47uVRMS)
关机模式:0.1uA
低压差:
800mV@输出=500mA,输出=1.8V
高PSRR:65dB@1KHz(典型值)
低温系数:±100ppm/℃
优良线路调节率:0.05%/V
高精度:±2%
输出电流限制
折回短路电流

CXPC3347电源管理单元PMU 1个同步降压和1个CMOS低压差Buck输出电流为1A同步buck是一种高效率的DC-toDC 降压开关调节器输出电流1A输入电压2-6V

产品手册

产品订购

产品简介

目录

  1. 1.产品概述       2.产品特点     jah嘉泰姆

  2. 3.应用范围       4.技术规格书下载(PDF文档)jah嘉泰姆

  3. 5.产品封装       6.电路原理图  jah嘉泰姆
    7.相关产品jah嘉泰姆

产品概述

返回TOP


The CXPC3347is a power management unit (PMU), with 1 synchronous Buck and 1 CMOS low-dropout regulators that delivers a maximum current of 1A for Buck’s output and a maximum current of 0.5A for LDO’s output.jah嘉泰姆
The synchronous buck is a high-efficiency, DC-to-DC step-down switching regulator, capable of delivering up to 1A of output current. The device operates from an input voltage range of 2.6V to 6V and provides an output voltage from 0.6V to VDD, making the buck ideal for low voltage power conversions. Running at a fixed frequency of 1.5MHz allows the use of small external components, such as ceramic input and output caps, as well as small inductors, while still providing low output ripples. This low noise output along with its excellent efficiency achieved by the internal synchronous rectifier, making the buck an ideal green replacement for large power consuming linear regulator. Internal soft-start control circuitry reduces inrush current. Short-circuit and thermal-overload protection improves design reliability.jah嘉泰姆
The LDO is a low-dropout regulator that delivers a maximum current of 0.5A output. Typical dropout voltage at 0.5A load current is 0.8V. It has excellent load and line transient response and good temperature characteristics, which can assure the stability of chip and power system. The output accuracy is set within 2% by trimming.jah嘉泰姆
Typical LDO output voltage: VOUT=1.8V. Other fixed voltage can be provided in the range of 1.2V~4.5V every 0.1V step. It also can be customized on command. LDO can also work under a wide input voltage ranging from 2V to 6V. They can provide foldback short-circuit protection and output current limit function.jah嘉泰姆
CXPC3347is available in lead (Pb)-free DFN2X2-8 (with exposed pad for heat dissipation) package.

   产品特点 返回TOPjah嘉泰姆


   High Efficiency : Up to 97%jah嘉泰姆

  • Capable of Delivering 1A
  • 1.5MHz Switching Frequency
  • No External Schottky Diode Needed
  • Low dropout 100% Duty operation
  • Internal Compensation and Soft-Start
  • Current Mode control
  • 0.6V Reference for Low Output voltages
  • Logic Control Shutdown (IQ<1uA)
  • Thermal shutdown, UVLO and OVP
  • LDO
  • Max output current is 0.5A
  • Input voltage range: 2 – 6V
  • Output voltage range: 1.2V~4.5V (customized on command every 0.1V step)
  • Low power consumption: 40uA (Typ.)
  • Low output noise (47uVRMS)
  • Shutdown mode: 0.1uA
  • Low dropout voltage:
  • 800mV@IOUT=500mA, VOUT=1.8V
  • High PSRR: 65dB@1KHz (Typ.)
  • Low temperature coefficient: ±100ppm/C
  • Excellent line regulation: 0.05%/V
  • Highly accurate: ±2%
  • Output current limit
  • Fold-back short circuit current

   应用范围 返回TOPjah嘉泰姆


    Distributed Power Systemsjah嘉泰姆
 Digital Set Top Boxesjah嘉泰姆
 Flat Panel Television and Monitorsjah嘉泰姆
 Wireless and DSL Modemsjah嘉泰姆
 Power source for cellular phones and various kind of PCSsjah嘉泰姆
 Battery Powered equipment
jah嘉泰姆

   技术规格书(产品PDF) 返回TOP jah嘉泰姆


     需要详细的PDF规格书请扫一扫微信联系我们,还可以获得免费样品以及技术支持jah嘉泰姆

      QQ截图20160419174301.jpgjah嘉泰姆

   产品封装图 返回TOPjah嘉泰姆


  jah嘉泰姆

   电路原理图 返回TOPjah嘉泰姆


jah嘉泰姆

  相关芯片选择指南 返回TOPjah嘉泰姆


源管理,可定制(PMU)
Part No. Configuration MODE VIN IQ FOSC Eff. FB Voltage IOUT Package
CXPC3343/B 1x 1A Sync Buck 2x 1A LDO PWM/PFM Buck 7V; LDO 12V Buck 50μA, LDO 2mA 1.5MHz 97% 0.6V DC/DC: 1A  LDO: 1A DFN3x3-12L 
CXPC3344 1 x 18V/2A Buck 1 x 6V/1.5A LDO PWM/PFM Buck 18V; LDO 6V Buck 0.8mA, LDO 100μA 500KHz 96% 0.8V DC/DC: 2A  LDO: 1.5A ESOP8  DFN2x3-8
CXPC3345 1 x 18V/2A Buck 2 x 6V/1.5A LDO PWM/PFM Buck 18V; LDO 6V Buck 0.8mA, LDO 100μA 500KHz 96% 0.8V DC/DC: 2A  LDO: 1.5A DFN3x3-12
CXPC3346 1 x 6V/1.5A Buck 2 x 6V/0.5A LDO PWM/PFM Buck 6V; LDO 6V Buck 40μA, LDO 35μA 1.5MHz 96% 0.6V DC/DC: 1.5A LDO: 0.5A ESOP8
CXPC3347 1 x 7V/1A Buck  1 x 6V/0.5A LDO PWM/PFM Buck 7V; LDO 6V Buck 50μA, LDO 35μA 1.5MHz 97% 0.6V DC/DC: 1A  LDO: 0.5A DFN2x2-8
CXPC3348 2 x 6V/1.5A Buck  2 x 6V/0.5A LDO PWM/PFM Buck 6V; LDO 6V Buck 40μA, LDO 35μA 1.5MHz 96% 0.6V DC/DC: 1.5A LDO: 0.5A QFN3x3-16

◀ 上一篇:CXPC3346同步buck是高效的单片同步buck稳压器采用恒定频率电流模式结构轻载高效PFM模式励磁涌流限制及软起动每个通道输出电流为0.5A输入电压2-6V 输出电压1.2V~4.5V

返回顶部

下一篇▶:CXPC3348电源管理单元PMU 2个同步块和2个CMOS低功耗Buck输出电流为1.5A每个LDO的输出电流为0.5A同步buck高效单片同步降压调节器恒定频率电流模式架构