CXUS65140从1.4V到5.5V的输入电压产生不受调节的负输出电压。该设备通常由5V或3.3V的预调节供电轨供电。由于其输入电压范围宽,两个或三个镍镉电池、镍氢电池或碱性电池以及一个锂离子电池也可以为其供电。
一个完整的DC/DC电荷泵逆变器只需要三个外部电容。整个转换器组装在一个小包装内,可以建造在一个50平方米的板上。通过用集成电路将启动时通常需要的肖特基二极管替换为负载,可以实现额外的板面积和组件数量减少。
该CXUS15140可以提供最大输出电流为200毫安,具有典型的转换效率大于80%,在宽的输出电流范围。
CXUS65140在SOT-23-6软件包中提供。它在-40℃到+85℃的环境温度范围内工作。
产品技术资料帮助
查看全部>
7.相关产品
产品概述 返回TOP
Only three external capacitors are required to build a complete DC/DC charge pump inverter. Assembled in a small package, the complete converter can be built on a 50mm2 board area. Additional board area and component count reduction is achieved by replacing the Schottky diode that is typically needed for start-up into load by integrated circuitry.
The CXUS65140 can deliver a maximum output current of 200mA with a typical conversion efficiency of greater than 80% over a wide output current range.
The CXUS65140 is available in SOT-23-6 package. It operates over an ambient temperature range of -40℃ to +85℃.
产品特点 返回TOP
• Inverts Input Supply Voltage
• Up to 200mA Output Current
• Input Voltage Range from 1.4V to 5.5V
• Quiescent Current: 1.5mA (TYP)
• 950kHz Switching Frequency
• Integrated Active Schottky Diode for Start-Up into Load
• -40℃ to +85℃ Operating Temperature Range
• Available in Green SOT-23-6 Package
应用范围 返回TOP
LCD Bias
GaAs Bias for RF Power Amps
Sensor Supply in Portable Instruments
Bipolar Amplifier Supply
技术规格书(产品PDF) 返回TOP
需要详细的PDF规格书请扫一扫微信联系我们,还可以获得免费样品以及技术支持!
产品封装图 返回TOP
电路原理图 返回TOP
a
电荷泵DC/DC转换器 |
||||||||||
Product |
CH |
Enable |
VCC(Min) (V) |
VCC(Max) (V) |
VOUT(V) |
IOUT (mA) |
Frequency (kHz) |
Iq(mA) |
SHDN Iq (μA) |
Package |
1 |
Y |
2.7 |
5 |
5 |
100 |
750 |
60 |
1 |
SOT-23-6 |
|
2 |
Y |
2.7 |
5 |
5 |
500 |
1700 |
70 |
2 |
TDFN-3x3-8L |
|
1 |
Y |
1.4 |
5.5 |
-VIN |
200 |
950 |
1500 |
1 |
SOT-23-6 |
|
1 |
N |
1.4 |
5.5 |
-VIN |
60 |
47 |
115 |
NA |
SOT-23-5 |
◀ 上一篇:电荷泵升压DC集成负载开关集成500mA负载开关电容电压转换器CXUS65139低的静态电流高效率输入电压2.7V至5.0V微功耗70μA 固定5.0V输出
下一篇▶:1.4V到5.5V输入电压DC电荷泵逆变器60mA输出电流85%转换效率固定47kHz开关频率CXUS65141双极放大器电源
|