2A连续输出电流CXSD62136B过电压保护可编程软启动开机复位检测固定340kHz开关频率低ESR电容稳定
发表时间:2020-04-27
浏览次数:67

1.产品概述                       2.产品特点6Bp嘉泰姆
3.应用范围                       4.下载产品资料PDF文档 6Bp嘉泰姆
5.产品封装图                     6.电路原理图                   6Bp嘉泰姆
7.功能概述                        8.相关产品6Bp嘉泰姆

一,产品概述(General Description)     CXSD62136 CXSD62136B is a 2A synchronous buck converter with integrated power MOSFETs.The CXSD62136 CXSD62136B design with a current-mode control scheme, can convert wide input voltage of 4.5V to 24V to the output voltage adjustable from 0.92V to 20V to provide excellent output voltage regulation. The CXSD62136 CXSD62136B is also equipped with Power-on-reset, softstart, and whole protections (over-temperature, and current-limit) into a single package.This device, available SOP-8, provides a very compact system solution external components and PCB area  6Bp嘉泰姆

二.产品特点(Features)6Bp嘉泰姆

Wide Input Voltage from 4.5V to 24V6Bp嘉泰姆
2A Continuous Output Current6Bp嘉泰姆
Adjustable Output Voltage from 0.92V to 20V6Bp嘉泰姆
Intergrated N-MOSFET6Bp嘉泰姆
Fixed 340kHz Switching Frequency6Bp嘉泰姆
Stable with Low ESR Capacitors6Bp嘉泰姆
Power-On-Reset Detection6Bp嘉泰姆
Programmable Soft-Start6Bp嘉泰姆
Over-Temperature Protection6Bp嘉泰姆
Over-Voltage Protection6Bp嘉泰姆
Current-Limit Protection with Frequency Foldback6Bp嘉泰姆
Enable/Shutdown Function6Bp嘉泰姆
Small SOP-8 Package6Bp嘉泰姆
Lead Free and Green Devices Available (RoHS Compliant)6Bp嘉泰姆

三,应用范围 (Applications)6Bp嘉泰姆

LCD Monitor/TV6Bp嘉泰姆
Set-Top Box6Bp嘉泰姆

DSL, Switch HUB6Bp嘉泰姆
Notebook Computer6Bp嘉泰姆

四.下载产品资料PDF文档 6Bp嘉泰姆


需要详细的PDF规格书请扫一扫微信联系我们,还可以获得免费样品以及技术支持6Bp嘉泰姆

 QQ截图20160419174301.jpg6Bp嘉泰姆

五,产品封装图 (Package)6Bp嘉泰姆


blob.png6Bp嘉泰姆

六.电路原理图6Bp嘉泰姆


blob.png6Bp嘉泰姆

Main Control Loop The CXSD62136 CXSD62136B is a constant frequency current mode switching regulator. During normal operation, the inter-6Bp嘉泰姆

nal N-channel power MOSFET is turned on each cycle when the oscillator sets an internal RS latch and would6Bp嘉泰姆
be turned off when an internal current comparator (ICMP) resets the latch. The peak inductor current at which ICMP6Bp嘉泰姆
resets the RS latch is controlled by the voltage on the COMP pin, which is the output of the error amplifier6Bp嘉泰姆
(EAMP). An external resistive divider connected between VOUT and ground allows the EAMP to receive an output6Bp嘉泰姆
feedback voltage VFB at FB pin. When the load current increases, it causes a slight decrease in VFB relative to6Bp嘉泰姆
the 0.92V reference, which in turn causes the COMP volt- age to increase until the average inductor current matches6Bp嘉泰姆
the new load current. 6Bp嘉泰姆
VIN Power-On-Reset (POR) and EN Under-voltage Lockout6Bp嘉泰姆
The CXSD62136 CXSD62136B keep monitoring the voltage on VIN pin to prevent wrong logic operations which may occur when VIN voltage is not high enough for the internal control circuitry to operate. The VIN POR has a rising threshold6Bp嘉泰姆
of 4.1V (typical) with 0.5V of hysteresis.An external under-voltage lockout (UVLO) is sensed at the EN pin. The6Bp嘉泰姆
EN UVLO has a rising threshold of 2.5V with 0.2V of hysteresis. The EN pin should be connected6Bp嘉泰姆
a resistor divider from VIN to EN.After the VIN and EN voltages exceed their respective voltage thresholds,6Bp嘉泰姆
the IC starts a start-up process and then ramps up the output voltage to the setting of output voltage.6Bp嘉泰姆
Over-Temperature Protection (OTP)6Bp嘉泰姆
The over-temperature circuit limits the junction tempera-ture of the CXSD62136 CXSD62136B. When the junction temperature ex-ceeds TJ = +160oC, a thermal sensor turns off the power MOSFET, allowing the devices to cool. The thermal sen-sor allows the converter to start a start-up process and regulate the output voltage again after the junction tem-6Bp嘉泰姆
perature cools by 50oC.The OTP is designed with a 50oC hysteresis to lower the average TJ during continuous thermal overload conditions,increasing lifetime of the lC.6Bp嘉泰姆
Enable / Shutdown6Bp嘉泰姆
Driving EN to ground places the CXSD62136 CXSD62136B in shutdown. When in shutdown, the internal power MOSFET turns off,all internal circuitry shuts down.6Bp嘉泰姆
Current-Limit Protection6Bp嘉泰姆
The CXSD62136 CXSD62136B monitors the output current, flowing through the N-Channel power MOSFET, and limits the6Bp嘉泰姆
IC from damages during overload, short-circuit and over- voltage conditions. 6Bp嘉泰姆
Frequency Foldback6Bp嘉泰姆
The foldback frequency is controlled by the FB voltage.When the FB pin voltage is under 0.6V, the frequency of6Bp嘉泰姆
the oscillator will be reduced to 110kHz. This lower fre-quency allows the inductor current to safely discharge,6Bp嘉泰姆
thereby preventing current runaway. The oscillator’s fre-quency will switch to its designed rate when the feedback6Bp嘉泰姆
voltage on FB rises above the rising frequency foldback threshold (0.6V, typical) again.6Bp嘉泰姆
Over-Voltage Protection6Bp嘉泰姆
The over-voltage function monitors the output voltage by FB pin. When the FB voltage increase over 120% of the6Bp嘉泰姆
reference voltage, the over-voltage protection compara-tor will force the low-side MOSFET gate driver high. This6Bp嘉泰姆
action actively pulls down the output voltage. As soon as the output voltage is within regulation, the OVP compara-6Bp嘉泰姆
tor is disengaged. The chip will restore its normal operation.6Bp嘉泰姆

八,相关产品         更多同类产品.......6Bp嘉泰姆